General
When mounted in rows without convection cooling, the nominal device current should only be led to a maximum of 80% due to the thermal effect during continuous operation (100% operating factor).<br/>Special precautionary measures must be taken in syst
Switching capacity ICN
Active current limitation
Minimum operating voltage Umin DC
Type
DIN rail module, one-piece
Maximum operating voltage Umax DC
Minimum operating current Imin
Max. operating current Imax
Maximum power dissipation for nominal condition
Switching capacity I<sub>CN</sub>
Active current limitation
Operating voltage
18 V DC ... 32 V DC
24 V DC
Nominal current I<sub>N</sub>
Required backup fuse
not required, integrated failsafe element
Dielectric strength
max. 32 V DC (Load circuit)
Active current limitation
Closed-circuit current range I0
typ. 25 mA ±5 mA (When switched on)
MTBF (IEC 61709, SN 29500)
6590000 h (at 40 °C with 80 % load)
7430000 h (at 25 °C with 80 % load)
Contact switching type
without electrical isolation
Minimum operating voltage U<sub>min</sub> DC
Maximum operating voltage U<sub>max</sub> DC
Minimum operating current I<sub>min</sub>
Max. operating current I<sub>max</sub>
Tightening torque
... 0.5 Nm
... 1.2 Nm
0.5 Nm
1.2 Nm
Conductor cross-section rigid
Cross section AWG
20 ... 6 (converted acc. to IEC)
Conductor cross-section flexible
Conductor cross-section, flexible [AWG]
20 ... 6 (converted acc. to IEC)
Conductor cross-section flexible (ferrule without plastic sleeve)
0.25 mm² ... 2.5 mm²
0.5 mm² ... 10 mm²
Flexible conductor cross-section (ferrule with plastic sleeve)
0.25 mm² ... 2.5 mm²
0.5 mm² ... 10 mm²
2 conductors with same cross section, rigid