Notes on operation
FBS 2-6... plug-in bridge for the input side (A2) and FBS-2-8... plug-in bridge for the output side (11/21)
The system installer must ensure the touch protection of the product (at voltages > 25 V AC/60 V DC). The product is a built-in device without protection against direct contact.
Input voltage range in reference to UN
Typical input current at UN
Insulation
Safe isolation, reinforced insulation
Date of last data management
Maximum power dissipation for nominal condition
Test voltage (Winding/contact)
4 kV AC (50 Hz, 1 min., winding/contact)
Nominal input voltage U<sub>N</sub>
Input voltage range
19.2 V DC ... 33.6 V DC (20 °C)
Input voltage range in reference to U<sub>N</sub>
Typical input current at U<sub>N</sub>
Protective circuit
Reverse polarity protection; Polarity protection diode
Surge protection; Freewheeling diode
Operating voltage display
Note regarding the switch contact
With tungsten leading contact
Maximum switching voltage
Minimum switching voltage
Limiting continuous current
10 A (Value is permissible if connections 11 and 21, as well as connections 14 and 24 are bridged.)
6 A
Maximum inrush current
165 A (20 ms)
800 A (200 µs)
Interrupting rating (ohmic load) max.
264 W (at 24 V DC, observe contact derating)
2750 VA (at 250 V AC, observe contact derating)
48 W (at 60 V DC)
50 W (at 110 V DC)
58 W (at 48 V DC)
80 W (at 220 V DC)
Utilization category CB Scheme (IEC 60947-5-1)
AC15, 6 A/250 V (N/O contact)
DC13, 2 A/24 V (N/O contact)
Conductor cross-section rigid
Conductor cross-section flexible
0.14 mm² ... 1 mm² (Ferrule with plastic sleeve, two conductors on double terminal block)
0.14 mm² ... 1.5 mm²
0.14 mm² ... 1.5 mm² (Ferrule with plastic sleeve)
Conductor cross-section AWG
26 ... 16 (flexible)
26 ... 16 (solid)
Degree of protection (Relay)