Typical input current at UN
Application
Filter to prevent interference
Input power dissipation for UN
Insulation
Basic insulation
Safe isolation, reinforced insulation, and 6 kV between input circuit and output contact current paths
Date of last data management
Maximum power dissipation for nominal condition
Test voltage (Winding/contact)
4 kV AC (50 Hz, 1 min., winding/contact)
Test voltage (Changeover contact/changeover contact)
2.5 kV AC (50 Hz, 1 min., changeover contact/changeover contact)
Nominal input voltage U<sub>N</sub>
Input voltage range
190 V AC ... 264 V AC (20 °C)
Nominal voltage (plugged-in electromechanical relay)
Typical input current at U<sub>N</sub>
Input power dissipation for U<sub>N</sub>
Input circuit
RC element with threshold value switch
Operating voltage display
Maximum switching voltage
250 V AC/DC (The separating plate PLC-ATP should be installed for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules. Potential bridging is then carried out with FBST 8-PLC... or ...FBST 500...)
Minimum switching voltage
Limiting continuous current
Interrupting rating (ohmic load) max.
140 W (at 24 V DC)
1500 VA (for 250 V AC)
44 W (at 110 V DC)
57 W (at 220 V DC)
60 W (at 60 V DC)
85 W (at 48 V DC)
Switching capacity
0.2 A (at 250 V, DC13)
2 A (at 24 V, DC13)
3 A (at 120 V, AC15)
3 A (at 24 V, AC15)
3 A (at 250 V, AC15)
Conductor cross-section rigid
Conductor cross-section flexible
0.14 mm² ... 2.5 mm²
0.2 mm² ... 2.5 mm² (Single ferrule)
2x 0.5 mm² ... 1.5 mm² (TWIN ferrule)
Conductor cross-section AWG
Tightening torque
0.45 Nm ... 0.55 Nm (Usually these terminal blocks must be supported during conductor connection (held by one hand, supported on the housing))