Nominal input voltage UIN
Connection method
Card edge connector
Push-in connection
Transmission speed
See system in which you use the Smart Element.
Start time until ready to operate
Description of the input
IO-Link ports in digital input (DI) mode
Number of inputs
max. 4 (IEC 61131-2 type 1)
Connection technology
2-, 3-conductor
3-conductor
Nominal input voltage U<sub>IN</sub>
Input voltage range "0" signal
Input voltage range "1" signal
Sensor current per channel
Output description
IO-Link ports in digital output (DO) mode
Nominal current per channel
Mounting position
See the system in which the Smart Element is used.
Overvoltage category
II (IEC 60664-1, EN 60664-1)
Pollution degree
2 (IEC 60664-1, EN 60664-1)
Maximum power dissipation for nominal condition
Nominal voltage for I/O supply
Supply voltage range
18 V DC ... 30 V DC (including all tolerances, including ripple)
19.2 V DC ... 30 V DC (including all tolerances, including ripple)
Nominal current for every IO-Link port
200 mA (at C/Q)
500 mA (at L+/L-)
Protective circuit
Reverse polarity protection; Polarity protection diode
Surge protection; See the system in which the Smart Element is used.
Supply voltage
24 V DC (using card edge connectors)
using card edge connectors
Current draw
max. 2030 mA (Internal current consumption + full load of the 4 IO-Link ports (4 x 500 mA))
typ. 2020 mA
Current consumption
min. 18 mA (without connected peripherals)
Protection
See the system in which the Smart Element is used.
Test voltage: Communications supply / 24 V supply (I/O)
Test voltage: Communications supply / functional ground
Test voltage: 24 V supply (I/O) / functional ground
Note on the connection method
Conductor cross-section, rigid
Conductor cross-section, flexible