IPD CAP W26 WP GY Protective cap

DANGER: Before mounting/removing the protective cap, make sure that no load is present.

NOTE: Only qualified electrical personnel may install and start up the IPD components.

For electrical values, refer to the current-carrying product.

Protective cap

IPD

no

3

26 mm

light gray (RAL 7035)

PA

NBR

V0

yes

50

IP66

IP68 (2 m / 24 h)

IP69K

-30 °C ... 100 °C

yes

• Position the protective cap centrally in front of the counterpart. The Phoenix Contact logo must be at the top on both mating elements. Make sure that the coding pin is located outside the pin connector pattern.• The connection is coded and only sn

• Make sure that the inside of the protective cap is clean and dry before fitting it.
• The self-locking rotary elements of the IPD PL CAP... protective cap and the IPD PL... connector are provided with a coding pin. Make sure not to damage the c

• Position the protective cap centrally in front of the counterpart. The Phoenix Contact logo must be at the top on both mating elements. Make sure that the coding pin is located outside the pin connector pattern.
• The connection is coded and on