Assembly note
<b>NOTE:</b> Observe the permissible bending radii when routing cables, since the degree of protection may be at risk if the bending forces are too high. Reduce mechanical loads upstream of the connector, e.g., by using cable ties.
Nominal voltage U<sub>N</sub>
Max. current carrying capacity per path
Current carrying capacity per slot
Sensor/actuator connection system
Connection method
Pluggable screw connection
Tightening torque, cover screw
Slot/position = Wire color or connection
1 / 2 (B) = GYPK
1 / 4 (A) = WH
1-8 / 1 (+ 120 V) = BN
1-8 / 3 (0 V) = BU
1-8 / 5 (PE) = GNYE
2 / 2 (B) = RDBU
2 / 4 (A) = GN
3 / 2 (B) = WHGN
3 / 4 (A) = YE
4 / 2 (B) = BNGN
4 / 4 (A) = GY
5 / 2 (B) = WHYE
5 / 4 (A) = PK
6 / 2 (B) = YEBN
6 / 4 (A) = RD
7 / 2 (B) = WHGY
7 / 4 (A) = BK
8 / 2 (B) = GYBN
8 / 4 (A) = VT
Material of contact, master cable side
Material of the contact carrier on the master cable side
Material of contact surface, master cable side
Conductor structure signal line
Conductor structure, voltage supply
Conductor cross-section
16x 0.5 mm² (Signal line)
3x 1 mm² (power line)
Wire diameter incl. insulation
1.5 mm ±0.1 mm (Signal line)
2.1 mm ±0.1 mm (power line)
Minimum bending radius, fixed installation
Minimum bending radius, flexible installation
Smallest bending radius, fixed installation
Smallest bending radius, movable installation
Dynamic load capacity (bending)
Max. bending cycles: 1500000, Bending radius: 10 x D, Traversing path: 2 m, Traversing rate: 2 m/s