Notes on operation
Separating plate PLC-ATP must be installed for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules. Potential bridging is then carried out with FBST 8-PLC... or FBST 500....
The PLC-ATP separating plate should be installed for safe isolation between adjacent modules
The system installer must ensure the touch protection of the product (at voltages > 25 V AC/60 V DC). The product is a built-in device without protection against direct contact.
Assembly note
in rows with zero spacing
The PLC-ATP separating plate is required at the start and end of every PLC terminal strip.
Typical input current at UN
8.5 mA (50 Hz)
9.5 mA (60 Hz)
Application
Filter to prevent interference
Date of last data management
Maximum power dissipation for nominal condition
Test voltage (Winding/contact)
4 kV<sub>rms</sub> (50 Hz, 1 min., winding/contact)
Rated surge voltage
4 kV (Safe isolation, reinforced insulation, and 6 kV between input circuit and output contact current paths)
Nominal input voltage U<sub>N</sub>
Input voltage range
93.5 V DC ... 168.3 V DC (20 °C)
94.8 V AC ... 168 V AC (20 °C)
Nominal voltage (plugged-in electromechanical relay)
Typical input current at U<sub>N</sub>
8.5 mA (50 Hz)
9.5 mA (60 Hz)
Protective circuit
Bridge rectifier
RC element
Maximum switching voltage
Minimum switching voltage
Limiting continuous current
Interrupting rating (ohmic load) max.
144 W (24 V DC)
1500 VA (250 V AC)
44 W (110 V DC)
57 W (220 V DC)
60 W (60 V DC)
96 W (48 V DC)
Switching capacity
0.2 A (at 250 V, DC13)
2 A (at 24 V, DC13)
3 A (at 24 V, AC15)
3 A (at 250 V, AC15)
Conductor cross-section rigid
Conductor cross-section flexible
0.14 mm² ... 2.5 mm²
0.2 mm² ... 2.5 mm² (Single ferrule)
2x 0.5 mm² ... 1.5 mm² (TWIN ferrule)
Conductor cross-section AWG