Notes on operation
Do not use to separate SELV/PELV circuits from other circuits, because safe isolation is not guaranteed. (applies to the optocoupler variants)
The system installer must ensure the touch protection of the product (at voltages > 25 V AC/60 V DC). The product is a built-in device without protection against direct contact.
Typical input current at UN
Input power dissipation for UN
Mechanical service life
approx. 3x 10<sup>7</sup> cycles
Date of last data management
Maximum power dissipation for nominal condition
Test voltage (Winding/contact)
5 kV<sub>rms</sub> (50 Hz, 1 min., winding/contact)
Test voltage (open contact)
1 kV<sub>rms</sub> (50 Hz, 1 min., open contact)
Nominal input voltage U<sub>N</sub>
Typical input current at U<sub>N</sub>
Input power dissipation for U<sub>N</sub>
Typical release time range
Maximum switching voltage
Minimum switching voltage
Limiting continuous current
Maximum inrush current
24 A (20 ms, N/O contacts)
Interrupting rating (ohmic load) max.
288 W (24 V DC)
3000 VA (250 V AC)
360 W (30 V DC)
Degree of protection (Relay)
Degree of protection (Installation location)
IP54 (Installation location)
Ambient temperature (operation)
Ambient temperature (storage/transport)