MTTF
293 Years (SN 29500 standard, temperature 25°C, operating cycle 21%)
55 Years (SN 29500 standard, temperature 40°C, operating cycle 100%)
Basic functions
Gigabit Ethernet extender in accordance with ITU G.9960
Management
Plug and Play, diagnostics via LEDs, PoL switch on the device
Redundancy
Ring segment redundancy (All devices at a ring segment)
Encryption methods
AES path encryption, Advanced Encryption Standard
Electrical isolation
VCC (US+GND) // Ethernet (PoE) // G.hn (without PoL) // FE
Test voltage data interface/power supply
1.5 kV AC (50 Hz, 1 min.)
Nominal supply voltage
24 V DC (Without PoL, without PoE)
48 V DC (With PoL or with PoE)
Power consumption
≤ 37.5 W (With PoL, without PoE)
≤ 37.5 W (Without PoL, with PoE)
≤ 7.5 W (Without PoL, without PoE)
≤ 82.5 W (With PoL, with PoE)
Protective circuit
Overload protection, protection against polarity reversal; Internal device protection: 2x 5 AF, internal series diode
Connection method
BNC female connector for coaxial cables, 75 Ω
Push-in spring connection
RJ45 jack, shielded
Conductor cross-section, flexible, with ferrule, without plastic sleeve
Conductor cross-section, flexible, with ferrule, with plastic sleeve
2 conductors with the same cross section, flexible, with TWIN ferrule with plastic sleeve
Single conductor/terminal point, rigid
≥ 0.5 mm² (PoL cables in accordance with DIN VDE 0100, part 523)
0.2 mm² ... 2.5 mm²
Single-wire/terminal point, flexible
≥ 0.5 mm² (PoL cables in accordance with DIN VDE 0100, part 523)
0.2 mm² ... 2.5 mm²
Conductor cross-section, flexible [AWG]
Signal
± 1 kV (Ethernet signal / asymmetrical: shielded Ethernet cable)
± 1 kV (Telecommunication lines, symmetrical, unshielded, without primary protection)
± 2 kV (Ethernet signal / symmetrical: cable to cable, unshielded G.hn cable)
± 2.2 kV (Ethernet, G.hn)
± 4 kV (Ethernet signal / asymmetrical: cable to ground, unshielded G.hn cable)
± 4 kV (Telecommunication lines, symmetrical, unshielded, with primary protection)
Ethernet
Serial transmission speed
Note on the connection method
Autonegotiation
CAT6
PoE port status: Always active<br/>Mode: Auto
Short-circuit-proof
Transmission length
< 100 m (shielded twisted pair)
≤ 1000 m (Depending on the quality of the data line)
Protocols supported
Protocol-transparent for TCP/IP, IPv4, and IPv6
Maximum output power
15 W (at ≤ 55°C)
30 W (at ≤ 50 °C)
Transmission speed
≤ 1000 Mbps (Depending on the quality of the data line)
Transmission method
QAM (quadrature amplitude modulation) carrier frequency method
Flammability rating according to UL 94
Vibration resistance in accordance with EN 60068-2-6/IEC 60068-2-6
Shock in accordance with EN 60068-2-27/IEC 60068-2-27
Ambient temperature (operation)
-40 °C ... 50 °C (Free standing, PoE up to 30 W)
-40 °C ... 55 °C (Free standing, PoE up to 15 W)
-40 °C ... 60 °C (Free standing, without PoE)
Ambient temperature (storage/transport)
Permissible humidity (operation)
10 % ... 95 % (non-condensing)
Permissible humidity (storage/transport)
10 % ... 95 % (non-condensing)
Identification
ISA-S71.04-1985 G3 Harsh Group A
Electromagnetic compatibility
Conformance with EMC Directive 2014/30/EU