Connection method
Card edge connector
Push-in connection
Transmission speed
100 bps ... 230400 bps (can be parameterized)
See system in which you use the Smart Element.
Start time until ready to operate
Note on the connection method
Use shielded cables. Connect both ends of the shield.
Required configuration data
Mounting position
See the system in which the Smart Element is used.
Special properties
End-to-end protocol
Modbus/RTU (client support)
Modbus/RTU (server support)
Process data width: 64 bytes
Transparent protocol
XON/XOFF protocol
Overvoltage category
II (IEC 60664-1, EN 60664-1)
Pollution degree
2 (IEC 60664-1, EN 60664-1)
Maximum power dissipation for nominal condition
Supply voltage
24 V DC (using card edge connectors)
using card edge connectors
Supply voltage range
19.2 V DC ... 30 V DC (including all tolerances, including ripple)
Current consumption
min. 6 mA (without connected peripherals)
Protective circuit
Reverse polarity protection; Polarity protection diode
Surge protection; See the system in which the Smart Element is used.
Protection
See the system in which the Smart Element is used.
Test voltage: Communications supply / 24 V supply (I/O)
Test voltage: Logic supply / RS-232 interface
Test voltage: Communications supply / functional ground
Test voltage: 24 V supply (I/O) / RS-232 interface
Test voltage: 24 V supply (I/O) / functional ground
Test voltage: RS-232 interface/functional ground
Conductor cross-section, rigid
Conductor cross-section, flexible
Conductor cross-section AWG
Conductor cross-section, flexible, with ferrule, with plastic sleeve
Conductor cross-section, flexible, with ferrule, without plastic sleeve
Ambient temperature (operation)
Air pressure (operation)
70 kPa ... 106 kPa (up to 3000 m above sea level)