Test voltage: 5 V supply of the local bus (UBus) / 24 V supply (I/Os)
Test voltage: 5 V supply of the local bus (UBus) / functional ground
Volume concentration H2S (Hydrogen sulfide)
Note on dimensions
The depth applies when a TH 35-7.5 DIN rail is used (in accordance with EN 60715).
Volume concentration NO2 (Nitrogen dioxide)
Volume concentration Cl2 (Chlorine)
EMC note
EMC: class A product, see manufacturer's declaration in the download area
Volume concentration SO2 (Sulfur dioxide)
Connection method
Bus base module
Push-in connection
Required configuration data
Protective circuit
Reverse polarity protection; parallel diode; with external 5 A fuse (only for commissioning)
Short-circuit protection, overload protection of the outputs; electronic
Surge protection; electronic (35 V, 0.5 s)
Limitation of the voltage induced on circuit interruption
Max. current carrying capacity per output
Maximum output current per module
16 A (from HW 02, provide external protection; if the total current of 8 A is exceeded, connect the supply at the power connector parallel via both terminal points.)
8 A (up to HW 01, fuse externally)
Output voltage when switched off
Output current when switched off
Nominal load, inductive
max. 12 VA (1.2 H, 48 Ω, with nominal voltage)
Nominal load, lamp
max. 12 W (at nominal voltage)
Nominal load, ohmic
max. 12 W (48 Ω, with nominal voltage)
Switching frequency
max. 1 per second (with inductive load)
max. 16 per second (with nominal lamp load)
max. 5500 per second (with ohmic load)
Reverse voltage resistance to short pulses
limited protection up to 0.5 A for 1 s
Behavior with overload
Shutdown with automatic restart
Behavior with inductive overload
Signal delay
max. 150 µs (when switched on)
max. 200 µs (during switching off with ohmic nominal load)
Output current with ground connection interrupt when switched off
Mounting position
any (no temperature derating)
Scope of supply
including bus base module and Axioline F connectors
Special properties
Extreme conditions version
Overvoltage category
II (IEC 60664-1, EN 60664-1)
Pollution degree
2 (IEC 60664-1, EN 60664-1)