Typ. starting time with Us
< 250 ms (when controlled via A1)
Rated control circuit supply voltage US
Relay type
Electromechanical relay with force-guided contacts in accordance with IEC/EN 61810-3
Typical response time
< 150 ms (automatic start)
Typ. starting time with U<sub>s</sub>
< 250 ms (when controlled via A1)
Typical release time
< 20 ms (when controlled via A1)
Restart time
< 1 s (Boot time, after switching on the supply voltage)
Recovery time
< 500 ms (following demand of the safety function)
Maximum power dissipation for nominal condition
3.1 W (U<sub>S</sub> = 30 V, I<sub>L</sub>² = 36A², P<sub>Total max</sub> = 1.3 W + +1.8 W)
Rated surge voltage/insulation
Rated control circuit supply voltage U<sub>S</sub>
Inrush current
< 10 mA
< 11.5 A (typ. with U<sub>S</sub>, Δt = 25 ns)
< 150 mA (typ. with U<sub>S</sub>, Δt = 25 ns)
max. 6 A
min. 3 mA
Protective circuit
Serial protection against polarity reversal; Suppressor diode
Short-circuit protection
Suppressor diode
Number of inputs
1 (non-safety-related)
1 (safety-related)
Input voltage range "0" signal
Input voltage range "1" signal
19.2 V ... 30 V
20.4 V ... 26.4 V
Input current range "0" signal
Filter time
1 ms (Test pulse width, high test pulse)
1 s (Test pulse rate for low test pulse)
100 ms (Test pulse rate, high test pulse)
3 ms (Test pulse width of low test pulses)
Unless switch-on pulses/light tests are safety-related, they should be disabled.
Max. permissible overall conductor resistance
150 Ω
150 Ω (Input and start circuits at U<sub>S</sub>)
Current consumption
< 10 mA
typ. 35 mA (at 24 V)
Voltage at input/start and feedback circuit
Output description
2 N/O contacts each in series, safety-related, floating
non-safety-related
Number of outputs
1 (digital, PNP)
1 (undelayed)
Switching voltage
max. 250 V AC/DC
min. 12 V AC/DC
Limiting continuous current
Sq. Total current
36 A<sup>2</sup> (observe derating)
Mechanical service life
10x 10<sup>6</sup> cycles
Output fuse
4 A gL/gG (for low-demand applications)
6 A gL/gG
Maximum inrush current
500 mA (Δt = 1 ms at U<sub>s</sub>)
Conductor cross-section rigid