Test voltage: 5 V supply of the local bus (UBus) / 24 V supply (I/Os)
Test voltage: 5 V supply of the local bus (UBus) / functional ground
Test voltage: DALI / 5 V supply of the local bus (UBus)
Note on dimensions
The depth applies when a TH 35-7.5 DIN rail is used (in accordance with EN 60715).
Connection method
Bus base module
Push-in connection
Note
The data apply for DALI bus 1 and DALI bus 2, respectively.
Supply voltage
24 V DC
5 V DC (via bus base module)
typ. 16 V DC (Bus voltage)
Output current with short-circuit
Current carrying capacity
max. 195 mA (Bus load, see derating)
Type of protection
Bus protected up to 250 V AC, maximum
Required configuration data
Mounting position
any (no temperature derating)
Scope of supply
including bus base module and Axioline F connectors
Special properties
integrated DALI power supply unit
Single master
two channels
Overvoltage category
II (IEC 60664-1, EN 60664-1)
Pollution degree
2 (IEC 60664-1, EN 60664-1)
Current draw
max. 470 mA (at nominal voltage)
max. 65 mA
typ. 250 mA
Power consumption
max. 325 mW
max. 8.8 W (both channels loaded with 195 mA)
Supply voltage range
19.2 V DC ... 30 V DC (including all tolerances, including ripple)
Current consumption
typ. 25 mA (without connected unit loads)
Protective circuit
Surge protection; electronic (35 V, 0.5 s)
Transient protection; Suppressor diode
Protection
max. 8 A (polarity reversal protection up to 5 A)
Test voltage: 5 V supply of the local bus / 24 V supply (I/Os)
Test voltage: 5 V supply of the local bus (U<sub>Bus</sub>) / functional ground
Test voltage: 24 V supply (I/O) / functional ground
Test voltage: DALI 1 / DALI 2
Test voltage: DALI / 5 V supply of the local bus (U<sub>Bus</sub>)
Test voltage: DALI/24 V supply (periphery)
Test voltage: DALI/functional ground
Note on the connection method
Please observe the information provided on conductor cross-sections in the “Axioline F: system and installation” user manual.
Conductor cross-section, rigid
Conductor cross-section, flexible
Conductor cross-section AWG