Typical input current at UN
Mechanical service life
approx. 3x 10<sup>7</sup> cycles
Date of last data management
Maximum power dissipation for nominal condition
Test voltage (Winding/contact)
6 kV (50 Hz, 1 min., winding/contact)
Nominal input voltage U<sub>N</sub>
Input voltage range
172.5 V AC ... 264.5 V AC (20 °C)
Nominal voltage (plugged-in electromechanical relay)
Typical input current at U<sub>N</sub>
Operating voltage display
Contact material
AgNi
AgNi, hard gold-plated
Note
<b>the following values are applicable if a gold layer is destroyed</b>
If the specified maximum values are exceeded, the gold plating is destroyed. The AgNi contact values are then valid for further operation; a reduction in length of service life is to be expected.
Maximum switching voltage
250 V AC/DC (Separating plate PLC-ATP must be installed for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules.)
30 V AC
36 V DC
Minimum switching voltage
Limiting continuous current
Interrupting rating (ohmic load) max.
1.2 W (24 V DC)
140 W (at 24 V DC)
1500 VA (for 250 V AC)
44 W (at 110 V DC)
60 W (at 220 V DC)
60 W (at 60 V DC)
85 W (at 48 V DC)
Switching capacity
0.2 A (220 V DC / 230 V AC (DC13), in acc. with DIN VDE 0660/IEC 60947)
0.2 A (at 110 V, DC13)
0.2 A (at 250 V, DC13)
2 A (24 V (DC13), in acc. with DIN VDE 0660/IEC 60947)
2 A (at 120 V, AC15)
2 A (at 24 V, AC15)
2 A (at 24 V, DC13)
2 A (at 250 V, AC15)
3 A (220 V DC / 230 V AC (AC15), in acc. with DIN EVDE 0660/IEC 60947)
Conductor cross-section rigid
Conductor cross-section flexible
0.14 mm² ... 2.5 mm²
0.2 mm² ... 2.5 mm² (Single ferrule)
2x 0.5 mm² ... 1 mm² (TWIN ferrule)
Conductor cross-section AWG
Flammability rating according to UL 94 (Housing)
Degree of protection (Relay)
Degree of protection (Relay base)
Ambient temperature (operation)