Input voltage range in reference to UN
Typical input current at UN
Environment
Attached to the vehicle body
Mechanical service life
approx. 3x 10<sup>7</sup> cycles
Date of last data management
Maximum power dissipation for nominal condition
Test voltage (Winding/contact)
5 kV<sub>rms</sub> (50 Hz, 1 min., winding/contact)
Test voltage (Changeover contact/changeover contact)
2.5 kV<sub>rms</sub> (50 Hz, 1 min., changeover contact/changeover contact)
Nominal input voltage U<sub>N</sub>
Input voltage range in reference to U<sub>N</sub>
Nominal voltage (plugged-in electromechanical relay)
Typical input current at U<sub>N</sub>
Protective circuit
Bridge rectifier
RCZ filter
Surge protection; Freewheeling diode
Wide-range electronics
Operating voltage display
Maximum switching voltage
250 V AC/DC (Separating plate PLC-ATP must be installed for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules.)
30 V AC
36 V DC
Minimum switching voltage
100 mV (10 mA)
12 V AC/DC
Limiting continuous current
2x 6 A (see derating curve)
50 mA
Interrupting rating (ohmic load) max.
1.2 W (at 24 V DC)
100 W (at 48 V DC)
140 W (at 24 V DC)
1500 VA (for 250 V AC)
44 W (at 110 V DC)
60 W (at 220 V DC)
60 W (at 60 V DC)
Note
<b>the following values are applicable if a gold layer is destroyed</b>
Switching capacity
0.2 A (at 110 V, DC13)
0.2 A (at 250 V, DC13)
2 A (at 120 V, AC15)
2 A (at 24 V, AC15)
2 A (at 24 V, DC13)
2 A (at 250 V, AC15)
Conductor cross-section rigid
Conductor cross-section flexible
0.14 mm² ... 2.5 mm²
0.2 mm² ... 2.5 mm² (Single ferrule)
2x 0.5 mm² ... 1 mm² (TWIN ferrule)
Conductor cross-section AWG
Flammability rating according to UL 94 (Housing)