Notes on operation
Separating plate PLC-ATP must be installed for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules. Potential bridging is then carried out with FBST 8-PLC... or FBST 500....
Typical input current at UN
3 mA (at UN = 220 V DC)
3.2 mA (at UN = 230 V AC)
Date of last data management
Maximum power dissipation for nominal condition
Test voltage (Winding/contact)
4 kV AC (50 Hz, 1 min., winding/contact)
Rated impulse withstand voltage
Input voltage range
171.6 V DC ... 154 V DC 253 (20 °C)
179.4 V AC ... 264.5 V AC (20 °C)
Nominal voltage (plugged-in electromechanical relay)
Typical input current at UN
3 mA (at UN = 220 V DC)
3.2 mA (at UN = 230 V AC)
Protective circuit
Bridge rectifier; Bridge rectifier
Operating voltage display
Maximum switching voltage
250 V AC/DC (The separating plate PLC-ATP should be installed for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules. Potential bridging is then carried out with FBST 8-PLC... or ...FBST 500...)
Minimum switching voltage
Limiting continuous current
Short-circuit current
200 A (conditional short-circuit current)
Interrupting rating (ohmic load) max.
140 W (at 24 V DC)
1500 VA (for 250 V AC)
18 W (at 60 V DC)
20 W (at 48 V DC)
23 W (at 110 V DC)
40 W (at 220 V DC)
Switching capacity
0.1 A (at 220 V, DC13)
0.2 A (at 110 V, DC13)
2 A (at 24 V, DC13)
3 A (at 120 V, AC15)
3 A (at 230 V, AC15)
3 A (at 24 V, AC15)
Conductor cross-section rigid
Conductor cross-section flexible
0.14 mm² ... 2.5 mm²
0.2 mm² ... 2.5 mm² (Single ferrule)
2x 0.5 mm² ... 1.5 mm² (TWIN ferrule)
Conductor cross-section AWG
Flammability rating according to UL 94 (Housing)
Degree of protection (Relay)