Notes on operation
FBS 2-6... plug-in bridge for the input side (A2) and FBS-2-8... plug-in bridge for the output side (11/21)
Input voltage range in reference to UN
Typical input current at UN
Insulation
Safe isolation, reinforced insulation
Date of last data management
Maximum power dissipation for nominal condition
Test voltage (Winding/contact)
4 kV AC (50 Hz, 1 min., winding/contact)
Nominal input voltage U<sub>N</sub>
Input voltage range
19.2 V DC ... 33.6 V DC (20 °C)
Input voltage range in reference to U<sub>N</sub>
Typical input current at U<sub>N</sub>
Protective circuit
Freewheeling diode; Freewheeling diode
Operating voltage display
Maximum switching voltage
250 V AC/DC (The separating plate PLC-ATP should be installed for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules. Potential bridging is then carried out with FBST 8-PLC... or ...FBST 500...)
Minimum switching voltage
Limiting continuous current
10 A (Value is permissible if connections 11 and 21, as well as connections 14 and 24 are bridged.)
6 A
Maximum inrush current
130 A (peak, at capacitive load, 230 V AC, 24 μF)
80 A (20 ms)
Interrupting rating (ohmic load) max.
264 W (at 24 V DC, observe contact derating)
2750 VA (at 250 V AC, observe contact derating)
48 W (at 60 V DC)
50 W (at 110 V DC)
58 W (at 48 V DC)
80 W (at 220 V DC)
Utilization category CB Scheme (IEC 60947-5-1)
AC15, 6 A/250 V (N/O contact)
DC13, 2 A/24 V (N/O contact)
Conductor cross-section rigid
Conductor cross-section flexible
0.14 mm² ... 1 mm² (Ferrule with plastic sleeve, two conductors on double terminal block)
0.14 mm² ... 1.5 mm²
0.14 mm² ... 1.5 mm² (Ferrule with plastic sleeve)
Conductor cross-section AWG
26 ... 16 (flexible)
26 ... 16 (solid)
Degree of protection (Relay base)