General
Current and voltage are determined by the plug used.
Note
The max. load current must not be exceeded by the total current of all connected conductors.
The rated insulation voltage when using the module connector is 500 V.
When using slip-on sleeves, their max. load current in accordance with DIN EN 61210 (Table 7) must be observed.
Product type
Feed-through terminal block
Maximum power dissipation for nominal condition
Number of connections per level
Internal cylindrical gage
Conductor cross-section rigid
Cross section AWG
24 ... 12 (converted acc. to IEC)
Conductor cross-section flexible
Conductor cross-section, flexible [AWG]
24 ... 14 (converted acc. to IEC)
Conductor cross-section flexible (ferrule without plastic sleeve)
Flexible conductor cross-section (ferrule with plastic sleeve)
Cross-section with insertion bridge, rigid
Cross-section with insertion bridge, flexible
2 conductors with same cross section, rigid
2 conductors with same cross section, flexible
2 conductors with same cross section, flexible, with ferrule without plastic sleeve
2 conductors with the same cross section, flexible, with TWIN ferrule with plastic sleeve
Maximum load current
30 A (with 4 mm² conductor cross-section)
Flammability rating according to UL 94
Insulating material group
Static insulating material application in cold
Relative insulation material temperature index (Elec., UL 746 B)
Fire protection for rail vehicles (DIN EN 45545-2) R22
Fire protection for rail vehicles (DIN EN 45545-2) R23
Fire protection for rail vehicles (DIN EN 45545-2) R24
Fire protection for rail vehicles (DIN EN 45545-2) R26
Surface flammability NFPA 130 (ASTM E 162)
Specific optical density of smoke NFPA 130 (ASTM E 662)