Notes on operation
the blocks can be bridged with one another via the conductor shaft, for corresponding plug-in bridges, see accessories
Note
For versions with 6 or 7 connections, it is enough to place one DIN rail adapter centrally per block and place flange elements after every other block.
The maximum load current of a single clamping unit must not be exceeded.
When aligning several blocks, it is recommended to either place a DIN rail adapter underneath the connection point or a flange element between the blocks.
When using the DIN rail adapter PTFIX-NS35, an aligned block must not protrude by more than a half.
Product type
Distributor terminal block
Maximum power dissipation for nominal condition
Number of connections per level
Internal cylindrical gage
Connection in acc. with standard
Conductor cross-section rigid
0.2 mm² ... 6 mm²
0.5 mm² ... 6 mm²
Cross section AWG
24 ... 10 (converted acc. to IEC)
Conductor cross-section flexible
Conductor cross-section, flexible [AWG]
24 ... 10 (converted acc. to IEC)
Conductor cross-section flexible (ferrule without plastic sleeve)
0.2 mm² ... 4 mm²
0.75 mm² ... 4 mm²
Flexible conductor cross-section (ferrule with plastic sleeve)
0.2 mm² ... 4 mm²
0.5 mm² ... 4 mm²
2 conductors with the same cross section, flexible, with TWIN ferrule with plastic sleeve
Conductor cross-section, rigid [AWG]
20 ... 10 (converted acc. to IEC)
Flammability rating according to UL 94
Insulating material group
Static insulating material application in cold
Temperature index of insulation material (DIN EN 60216-1 (VDE 0304-21))
Relative insulation material temperature index (Elec., UL 746 B)
Specification
DIN EN 50155 (VDE 0115-200):2018-05
Spectrum
Long life test category 2, bogie-mounted
Frequency
f<sub>1</sub> = 5 Hz to f<sub>2</sub> = 250 Hz
Test directions
X-, Y- and Z-axis
X-, Y- and Z-axis (pos. and neg.)