Nominal input voltage UIN
Nominal input current at UIN
Connection method
Card edge connector
Push-in connection
Transmission speed
See system in which you use the Smart Element.
Start time until ready to operate
Required configuration data
Description of the input
Based on EN 61131-2 type 3 for PNP inputs
Input voltage range "0" signal
19 V DC ... 30 V DC (At U<sub>P</sub> = 24 V DC)
Input voltage range "1" signal
0 V DC ... 13 V DC (At U<sub>P</sub> = 24 V DC)
Nominal input voltage U<sub>IN</sub>
Nominal input current at U<sub>IN</sub>
Current flow
linear until nominal current is reached, then constantly approx. 2.4 mA
Protective circuit
Polarity reversal protection of the inputs; Diode
Reverse polarity protection; Polarity protection diode
Surge protection; See the system in which the Smart Element is used.
Mounting position
See the system in which the Smart Element is used.
Overvoltage category
II (IEC 60664-1, EN 60664-1)
Pollution degree
2 (IEC 60664-1, EN 60664-1)
Maximum power dissipation for nominal condition
Supply voltage
24 V DC (using card edge connectors)
using card edge connectors
Supply voltage range
19.2 V DC ... 30 V DC (including all tolerances, including ripple)
Current consumption
min. 15 mA (without connected peripherals)
Protection
See the system in which the Smart Element is used.
Test voltage: Communications supply / 24 V supply (I/O)
Test voltage: Communications supply / functional ground
Test voltage: 24 V supply (I/O) / functional ground
Note on the connection method
Conductor cross-section, rigid
Conductor cross-section, flexible
Conductor cross-section AWG
Conductor cross-section, flexible, with ferrule, with plastic sleeve
Conductor cross-section, flexible, with ferrule, without plastic sleeve