Connection method
Card edge connector
Push-in connection
Transmission speed
See system in which you use the Smart Element.
Start time until ready to operate
Required configuration data
Protective circuit
Reverse polarity protection; parallel diode
Short-circuit and overload protection; Electronic
Surge protection; See the system in which the Smart Element is used.
Limitation of the voltage induced on circuit interruption
Max. current carrying capacity per output
Maximum output current per module
max. 6 A (Also make sure that the maximum permissible current of 6 A is not exceeded!)
Output voltage when switched off
min. 23 V (At U<sub>P</sub> = 24 V DC)
Output current when switched off
Nominal load, inductive
12 VA (1.2 H, 48 Ω, with nominal voltage)
Nominal load, lamp
12 W (at nominal voltage)
Nominal load, ohmic
12 W (48 Ω, with nominal voltage)
Switching frequency
max. 1 per second (with inductive load)
max. 1200 per second (With resistive load, at least 50 mA load current)
max. 16 per second (with nominal lamp load)
Reverse voltage resistance to short pulses
limited protection up to 0.5 A for 1 s
Behavior with overload
Shutdown with automatic restart
Behavior with inductive overload
Signal delay
max. 100 µs (when switched off, with at least 50 mA load current)
max. 100 µs (when switched on)
Mounting position
See the system in which the Smart Element is used.
Overvoltage category
II (IEC 60664-1, EN 60664-1)
Pollution degree
2 (IEC 60664-1, EN 60664-1)
Maximum power dissipation for nominal condition
Supply voltage
24 V DC (using card edge connectors)
using card edge connectors
Supply voltage range
19.2 V DC ... 30 V DC (including all tolerances, including ripple)
Current consumption
min. 14 mA (without connected peripherals)
Protection
See the system in which the Smart Element is used.
Test voltage: Communications supply / 24 V supply (I/O)
Test voltage: Communications supply / functional ground
Test voltage: 24 V supply (I/O) / functional ground