Input voltage Ui
30 V (Current and voltage input)
Input current Ii
120 mA (Current and voltage input)
Configuration
DIP switches
Potentiometer
Input power Pi
0.9 W (Current and voltage input)
Max. internal inductance Li
Electrical isolation between input and output
Max. internal capacitance Ci
75 nF (for current input)
Negligible at voltage input
Max. output voltage Uo
0 V DC (Current input)
3.9 V DC (Voltage input)
Max. output current Io
0 mA (Current input)
0.1 mA (Voltage input)
Max. output power Po
0 mW (Current input)
0.5 mW (Voltage input)
Maximum temperature coefficient
Maximum transmission error
Safety-related maximum voltage Um
IIC: Max. external inductivity Lo / Max. external capacitance Co
100 mH / 3.3 µF, 5 mH / 4.7 µF, 1 mH / 6.3 µF
IIB/IIIC: Max. external inductivity Lo / Max. external capacitance Co
100 mH / 16 µF, 5 mH / 24 µF, 1 mH / 35 µF
IIA/I: Max. external inductivity Lo / Max. external capacitance Co
100 mH / 24 µF, 5 mH / 35 µF, 1 mH / 48 µF
Standards/regulations
EN 61000-6-4
GB/T 3836.1
GB/T 3836.3
GB/T 3836.4
GB/T 3836.8
IEC/EN 60079-11
IEC/EN 61010-1
Rated insulation voltage
250 V AC
300 V AC
375 V AC
Nominal supply voltage range
12 V DC ... 24 V DC -20 % ... +25 %
Typical current consumption
Voltage input signal
0.1 V ... 10 V
0.1 V ... 10.5 V (Maximum range)
Total error of the voltage input maximum
Current input signal
0.18 mA ... 21 mA (Maximum range)
0.2 mA ... 20 mA
Total error of the current input maximum
Input resistance of voltage input
Input resistance current input
Switching threshold "0" signal current
Configurable via DIP switch (in 1.25% increments) and potentiometer (linearly up to 2% of the switching threshold set via the DIP switch)
Switching hysteresis
off: approx. 0.5 %, on: approx. 1 %
Line fault detection
< 0.1 mA (Line break)
> 21.1 mA (Short circuit)
Contact material
AgSnO<sub>2</sub>, hard gold-plated
Max. switching current
≤ 0.2 A DC (ohmic load, 120 V DC)
≤ 1 A DC (ohmic load, 24 V DC, 50 mW)
≤ 4 A AC (cos phi = 1)
Conductor cross-section rigid