General
Separating plate PLC-ATP must be installed for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules. Potential bridging is then carried out with FBST 8-PLC... or FBST 500....
The PLC-ATP separating plate is required at the start and end of every PLC terminal strip.
The PLC-ATP separating plate should be installed for safe isolation between adjacent modules
The system installer must ensure the touch protection of the product (at voltages > 25 V AC/60 V DC). The product is a built-in device without protection against direct contact.
Typical input current at UN
7 mA (50 Hz)
8 mA (60 Hz)
Application
Filter to prevent interference
Insulation
Safe isolation, reinforced insulation
Date of last data management
Maximum power dissipation for nominal condition
Test voltage (Winding/contact)
4 kV AC (50 Hz, 1 min., winding/contact)
Nominal input voltage U<sub>N</sub>
Input voltage range
85.8 V DC ... 154 V DC (20 °C)
93.6 V AC ... 168 V AC (20 °C)
Nominal voltage (plugged-in electromechanical relay)
Typical input current at U<sub>N</sub>
7 mA (50 Hz)
8 mA (60 Hz)
Protective circuit
Bridge rectifier
RC element
Maximum switching voltage
250 V AC/DC (The separating plate PLC-ATP should be installed for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules. Potential bridging is then carried out with FBST 8-PLC... or ...FBST 500...)
Minimum switching voltage
Limiting continuous current
Interrupting rating (ohmic load) max.
140 W (24 V DC)
1500 VA (250 V AC)
18 W (60 V DC)
20 W (48 V DC)
23 W (110 V DC)
40 W (220 V DC)
Switching capacity
0.1 A (at 220 V, DC13)
0.2 A (at 110 V, DC13)
2 A (at 24 V, DC13)
3 A (at 120 V, AC15)
3 A (at 230 V, AC15)
3 A (at 24 V, AC15)
Conductor cross-section rigid
Conductor cross-section flexible
0.14 mm² ... 2.5 mm²
0.2 mm² ... 2.5 mm² (Single ferrule)
2x 0.5 mm² ... 1.5 mm² (TWIN ferrule)
Conductor cross-section AWG
Flammability rating according to UL 94 (Housing)