Typ. starting time with Us
500 ms (with U<sub>s</sub> when controlled via A1)
Rated control circuit supply voltage US
Rated control supply current IS
Application
Emergency stop
Light grid
Safety door
Relay type
Electromechanical relay with force-guided contacts in accordance with IEC/EN 61810-3
Typical response time
< 50 ms (automatic start)
< 50 ms (manual, monitored start)
Typ. starting time with U<sub>s</sub>
500 ms (with U<sub>s</sub> when controlled via A1)
Typical release time
< 10 ms (when controlled via A1; applicative deactivation via A1/A2 is not permitted)
< 25 ms (when controlled via S12 and S22 (only for undelayed contacts))
Delay time range
0.2 s ... 300 s ±5 % (can be set for 47/48, 57/58)
Recovery time
100 ms (Availability time after activating the sensor circuit during manual start)
500 ms (following demand of the safety function)
Start pulse length
min. 500 ms (manual start)
Maximum power dissipation for nominal condition
9.91 W (at U<sub>S</sub> = 30 V, I<sub>L</sub>² = 144 A²)
Rated surge voltage/insulation
See data sheet, section “Insulation coordination”.
Rated control circuit supply voltage U<sub>S</sub>
Rated control supply current I<sub>S</sub>
Power consumption at U<sub>S</sub>
Inrush current
< 11 mA (typ. with U<sub>S</sub>)
< 8.6 mA (typ. with U<sub>S</sub>)
max. 6 A
min. 5 mA
typ. 28 A (Δt = 30 µs at U<sub>s</sub>)
Filter time
1 ms (For the logic. At A1 in the event of voltage dips at U<sub>s </sub>)
max. 1 ms (Test pulse width of low test pulses)
max. 3 ms (Test pulse width of low test pulses)
min. 21 ms (Test pulse rate for low test pulse)
Protective circuit
Serial protection against polarity reversal
Suppressor diode
Varistor
Description of the input
non-safety-related
safety-related sensor inputs
Input voltage range "0" signal
Input voltage range "1" signal
Input current range "0" signal
Max. permissible overall conductor resistance
Current consumption
< 3.2 mA (typ. with U<sub>S</sub>)
< 4.5 mA (typ. with U<sub>S</sub>)
Output description
2 N/O contacts each in series, safety-related, floating
non-safety-related
PNP
Number of outputs
1
2
2 (delayed: 47/48, 57/58)
3 (undelayed: 13/14, 23/24/34)
Contact material
AgCuNi +0.2 µm ... 0.4 µm Au / AgSnO<sub>2</sub> +0.2 µm Au
Switching voltage
max. 250 V AC/DC
min. 12 V AC/DC
Switching capacity
3 A (230 V (AC 15))
4 A (24 V (DC13))
Limiting continuous current
Sq. Total current
144 A<sup>2</sup> (observe derating)
Switching frequency
0.1 Hz (depending on the set delay time)
Mechanical service life
10x 10<sup>6</sup> cycles